The Garrett® direct fit F150 charge air cooler boasts an 83% larger core than stock to provide an estimated 25 degree Fahrenheit reduction in air temperature and a 30% reduction in pressure drop.
C.A.R.B. EO# D-794
Supports up to 750 Horsepower
Drain plug to relieve condensation
*Not engineered to fit any other applications
Cast aluminum end tanks
Advanced offset fin design
TIG welded for improved strength
Vacuum brazed bar-and-plate design
83% larger aluminum intercooler core
Up to 25 degree reduction in charge air temp
Granted by the California Air Resource Board (C.A.R.B), executive order #D-794 allows the 870702-6001 direct fit performance charge air cooler to be used on specific emission controlled vehicles.
California is the only state that is permitted to issue emissions standards with an approval form the Environmental Protection Agency.
Obtaining a C.A.R.B certification identifies this intercooler will not increase vehicle emissions.
+ 16 horsepower increase over OE at full heat saturation.
This direct fit performance charge air cooler installs in one and a half hours using basic hand tools
Reuses the factory hoses, clamps, bolts
Can be installed without removing the front bumper
Intercooler comes with a new screw for the blow off valve bracket
The Garrett direct fit performance charge air cooler comes with a fully machined drain plug to relieve condensation buildup commonly found in the F150 platform. The bolt can be removed with a 3/8 open ended wrench.
Installers can test for condensation by turning the engine on, transmission in park, remove the bolt and place a catch can under the opening. Observe for any fluids. If fluid is present, gently rev the engine several times to dispel. Be sure to dispose of fluid with your local waste management facility.
|Intercooler Width (Inches)||9.43"|
|Intercooler Height (Inches)||5.32"|
|Intercooler Length (Inches)||21"|
|Intercooler Weight (lbs)||30|